LS ELECTRIC XGL-EFMF, User Manual, Page: 65 / 364

Chapter 3 Product Installation and trial operation
3-20
1) ONE IP Solution
If ONE IP Solution is used, when master switching occurs due to error, communication disconnection, etc.,
the IP address of the FEnet module mounted on the master base and the FEnet module mounted on the
standby base are exchanged. To do this, an individual module reset is performed after the master switch.

If you check ONE IP Solution, ONE IP Solution is activated and only one IP is registered.

When using ONE IP Solution, only an even number can be entered. The configured IP address becomes the
Ethernet module IP address of the master base.

The Standby base Ethernet module IP address becomes Master base Ethernet module IP a 1.
2) TCP/IP setting(XGR CPU series)
After setting one of A-side or B-side, use copy button or set station number and IP independently.
Classification Content
Station No
Station number used for high speed link and RAPIEnet communication between
Ethernet modules.
- Modules on the same network should not have duplicate station numbers.
- The station number range of the high speed link communication is 0 ~ 63.
- The station number range of the RAPIEnet communication (including Smart
Extension) is 0 ~ 220.
* Precautions for V6.0 or higher
- When RAPIEnet is enabled, it is set as RAPIEnet's station number.
- When using Modbus RTU / ASCII and XGT Cnet client, it is set as station number.
Media
Select the communication media you want to use.

AUTO(electric): Automatically sets the media settings of the currently installed
module.

10M/HALF: 10Mbps Half Duplex Electric

10M/FULL: 10Mbps Full Duplex Electric

100M/HALF: 100Mbps Half Duplex Electric

100M/FULL: 10Mbps Full Duplex Electric

100M/FX/HALF: 100Mbps Half Duplex optical

100M/FX/FULL: 100Mbps Full Duplex optical

1G/FULL: 1Gbps Full Duplex Electric

1G/FX/FULL: 1Gbps Full Duplex optical
IP address Set the IP address of the Ethernet module.
Subnet mask
This is the value for classifying whether the destination station is in the same
network with its own station or not.
Gateway
Set the gateway module address (router address) for sending and receiving data
through a station or a public network that uses a different network from your own
station.
DNS Server Specifies the domain name server.
DHCP
DHCP (Dynamic Host Configuration Protocol) is used when you want to use
dynamic IP (use when connecting ADSL line) without using Fixed IP.
Copy A -> B,Copy B ->
A
It is activated when One IP Solution is not checked. After setting Standard Settings
parameters of A side or B side, click A-> B Copy or B-> A to copy the set
parameters to the other side.
Relay Used to send data frames received on the port to the other port.
OPC UA Enable / Disable the OPC UA server function.(Only V7.x version is supported)
No. of Dedicated
Connections
The maximum number of TCP-dedicated services that can be connected at the
same time.
- V6.0 or less version: Available range is 1~ 16 and default is 3.
- V6.0 or higher version: The number of server connections that can be connected
simultaneously is 64, and is not affected by the number of dedicated connections in
the basic parameters.