LS ELECTRIC XGL-EFMF, User Manual, Page: 46 / 364

Chapter 3 Product Installation and trial operation
1
Chapter 3 Product Installation and trial operation
3.1 Installation
3.1.1 Preparation for operating
(1) Ethernet module system configuration
1) Check the basic elements necessary for the system configuration and select a proper communication
module.
2) Select a cable for the communication module.
3) When installing the Communication module, make sure that there is no foreign substance in the base
connector to be mounted, and check that the connector pin of this module is not damaged.
4) Ethernet module can be mounted on the main base and expansion base, but it is recommended to use it on
the main base. However, in case of XGR system, it can be installed only on the main base.
5) When installing the module, insert the raised part of the lower part of the module into the base groove
without connecting the communication cable, and apply enough force until the upper part is completely
locked with the base locking device. If it is not locked, there may be abnormality in the interface with the CPU
module.
6) Cables used for communication module should be installed referring to the standard.
7) Ethernet switches and cables required for communication with the Ethernet module should be selected as
standard products.
(2) Switch module system configuration
1) When installing the switch module, make sure that there is no foreign substance in the base connector to be
mounted, and check that the connector pin of this module is not damaged.
2) XGL-EH5T module is powered from the base module. Therefore, the switch module is not recognized by the
CPU and can be installed in either the expansion or the main base slot.
3) When installing the module, insert the raised part of the lower part of the module into the base groove
without connecting the communication cable, and enough force until the upper part is completely locked with
the base locking device. If the lock is not locked, the module may be detached from the base module.
4) The XOL-ES4T / ES4H Switch module should be fixed to the panel and supplied with a 24 VDC connector.