LS ELECTRIC XGL-EFMF, User Manual, Page: 220 / 364

Chapter 6 P2P service
6-37
6.6.3 Create block
Parameter setting of P2P block is to send / receive the message of E -mail setting. Click the P2P block and set
the E-mail button to select the corresponding P2P command.
Category Contents
E-mail Enable your email service.
P2P function
ESEND: Sends an email.
ERECEIVE: Receives an email. Only one can be registered. .
Start condition
Enter the area to be used as the start condition.
Memory areas and flags are available.
(1) Click to enter the settings.
Send
Mail Message
Number
Enter the index number from the Message Index among the Email Setting
of P2P. Decide the title and data of the mail.
Mail Address
Number
Set the registration number set in the address book. Decide to whom you
wish to send mail.
* If you want to send it to multiple people, you can set it using a group.
However, the mail addresses of the recipient group should have been
entered in advance before specifying the group. The number of groups
that can be specified is limited to 10 groups.
Mail data
Indicates the start address of the data to be sent. The size of data to be
transmitted is the number of arrays (10 bytes) starting from the first array
corresponding to MB[10] within the email message setting.
Rece
ive
Mail information This is the area where mail information is saved.
Mail message Saves a received mail message to the PLC memory.