P a g e 27 | 36
LPS-Lasersysteme Siegmund Ruff / CEO Haidschwaerze 18 72131 Ofterdingen Germany
Phone: +49 7473 271177 www.lps-laser.de [email protected]
6.3
DMX fault protection
SimPlex laser systems automatically detect a valid DMX512 signal. If the signal fails as a result of
interruptions of the DMX connection, the output of the show automatically switches to black out,
when the system is in DMX mode.
In addition the invalidity of a DMX signal is flashing the word "SIGNAL" in the display indicates. This is
the case, or the data lines when there is no DMX connection, are incorrectly set or, in all other cases
a signal disability.
XLR pin configuration for DMX:
Pin 1: GND
Pin 2: Data-
Pin 3: Data+
6.4
Activation of the DMX mode
1.
Make sure that the laser system is connected to a DMX controller with at least 26 channels.
2.
Switch on the laser system.
3.
Press the menu encoder 2 seconds long
4.
Select the point MODE at the main menu
5.
Select mode “DMX”
6.
Enter the desired DMX start address by turning the menu encoder and confirm this by
pressing.