Doc: I470GB10_16.docx 18/10/2016
p. 14 / 19
C06
Restore default parameters
Advanced
Resets all parameters to their default values.
C07
Save parameters to backup
memory
Advanced
Saves a copy of all current parameter settings to backup memory for future use.
C08
Load parameters from backup
memory
Advanced
Loads the parameter settings saved in backup memory as active values.
C09
Purge solenoid valve
Advanced
Energises the fuel solenoid valve without starting the engine. The output remains active for max 5 minutes or until the
OFF button is pressed.
C10
Force I/O
Advanced
Enables test mode so that all outputs can be energised manually.
Caution!
The installer is entirely responsible for controlling outputs in this mode.
C11
Adjust resistive sensor offset
Advanced
Calibrates resistive sensors by adding/subtracting a value in Ohms to the resistance measured by them, to
compensate for cable length or resistance offsets. Calibration is made possible by displaying the measured value in
engineering quantities.
Installation
The RGK4...SA controller is designed to be flat panel mounted. With correct installation and the optional seal, the RGK400SA controller achieves a front protection rating of
IP65.
Insert the controller in the hole in the panel, making sure that the seal, if present, is correctly positioned between the panel and controller's casing.
On the inside of the panel, proceed as shown in the figures below to fit the four fixing clips, taking care to slide the clips all the way towards the front panel.
To make the electric connections, refer to the connection diagrams shown in the relevant section and to the requirements listed in the technical characteristics table.