Instruction manual for installation, maintenance and use
Gas Kettles PMK.G...
PMK.G-GB-07
Page
16 di 36
2.5.2. REPLACEMENT OF INJECTORS FOR PILOT
BURNER
–
The injector of the pilot burner can be reached by removing the lower front panel.
Remove the side and lower screws.
–
The pilot burner is in the front of the combustion chamber.
–
Unloose the screw and replace the injector with an appropriate one.
2.5.3. MINIMUM OUTPUT ADJUSTMENT
–
Once the appliance has been switched on, set the cock knob on the minimum position.
−
Remove the cock knob that will reveal a small hole on the panel of the appliance.
Turn the minimum adjustment screw on the cock with a screwdriver through the hole on
the panel.
Warning! Measure the minimum output pressure directly at the output pressure
connection on the injector tube (see figure “Measuring gas pressure”)
−
Set the output pressure of the gas cock according to the figures stated in table 4 -
Minimum output setting).
−
After setting, seal the adjustment screw!
Warning! After each conversion, it is necessary to check tightness and operation!
2.6. MAINTENANCE OF THE APPLIANCE
Warning! : All maintenance operations shall only be performed by a technically
qualified service centre!
−
To ensure correct and safe operation, the appliance must be inspected and serviced at
least once a year only. Maintenance includes also to control the components and tear
of pipes, feeding pipes etc..
It is advisable to replace worn components during maintenance operations to avoid the
need for other maintenance calls and unexpected failures.
−
It is also advisable to apply for a maintenance contract with the customer.
