38
Using the Main Menu
Adjusting the Video Margin
If you connect your DVR to a BNC
monitor, you can adjust the video
margins.
NOTE:
You must select the BNC output
mode to adjust the margins. Press
0
on the remote control three times to
switch the output mode between
BNC mode and VGA mode. When
BNC mode is selected, the mouse
cursor appears on the BNC monitor.
To adjust the video margin:
1
Click the
Output
tab.
2
Click the
Margin
button.
3
Drag the sliders to the left or right to
adjust the Left, Right, Top, or Bottom
Margin.
4
Click
Apply
to save your settings and click
OK
to confirm.
Adding Privacy Zones
A privacy zone allows you to block out
portions of each channel with a black
square.
To configure a privacy zone:
1
Click the
Privacy Zone
tab.
2
In the
Channel
drop-down menu, select
the channel you wish to configure.
3
Configure the following:
•
Channel
: Select the channel you wish to
configure.
•
Privacy Zone
: Select
Enable
to enable
privacy zones or
Disable
to disable privacy
zones.
•
Area Setup
: Select the
Area1~4
checkboxes to enable up to 4 privacy
zones.
NOTE:
16-channel ECO Blackbox (LH016)
supports only one privacy area per
channel.
4
Click the
Setup
button next to Mask Area.
The Privacy Area setup screen opens.
• Click on a privacy area and drag to change
its location.
ATTENTION
: Areas covered by privacy
zones are not visible in recordings.
Privacy Zone
Click and drag to move privacy zones
Click on the edge and drag to resize