Lorex LH150 ECO4 SERIES, Instruction Manual

Page: 157 / 178

Replacing the Hard Drive (LH150 Series) 24
3. Next, install the hard drive. This step depends on if you are installing a 3.5” or 2.5” hard
drive.
If you are installing a 3.5” hard drive:
1 2 3
3.1. Remove the 4 screws holding the hard drive bracket and remove the bracket from the DVR.
3.2. Place the hard drive in the bracket and insert 4 screws to secure the hard drive to the bracket.
3.3. Place the hard drive and bracket back in the DVR with the power and data connectors facing
the middle and replace the hard drive bracket screws.
If you are installing a 2.5” hard drive:
0
0
1
0
2
3.1. Place the hard drive over one of the two sets of screw holes with the power and data connec-
tors facing the center of the DVR.
3.2. Hold the hard drive in place and carefully turn the DVR over. Insert 4 hard drive screws to se-
cure the hard drive. Turn the DVR back over.
WARNING
Make sure to hold the hard drive in place while inserting the hard drive screws and turning
the DVR to avoid damaging the DVR.
4. Connect the power and data cables.
0
5. Replace the DVR cover.
6. Replace the side and cover panel screws.
#LX400012; r. 2.0/12066/12066; en-US
147