LORCH M-Pro BasicPlus, Operation Manual

Page: 50 / 328

Messages
- 50 -
10.13
13 .7 Special functions
Gas test
Â
Turn the unit OFF using main switch 9.
Â
Press the torch key and keep it pressed.
Â
Turn the unit ON using main switch 9.
9
The solenoid valve of the unit will go on
and the gas supply can be tested/adjust
-
ed. The function is active for 30 seconds
and will be automatically stopped. Re-
pressing the torch key. can interrupt the
gas test.
Fan test
Â
Turn the unit ON using main switch 9.
9
The fan will start for function purposes.
Operation panel test
Â
Press the mode key 60 for at least 5 sec
-
onds.
9
All operation displays will flash for approx.
20 seconds.
13 .8 Reset setting
Master reset
Attention All personal settings
will be lost .
All welding and secondary param
-
eters are reset to their factory set
-
tings.
Â
Turn the unit OFF using main switch 9.
Â
Press the mode key 60 and keep it
pressed.
Â
Turn the unit ON using main switch 9.
9
All symbols and displays will light up
shortly to confirm reset.
i
During operational faults/malfunction , the
7-segment display 47 displays an error
code.
As long as there is an error code
on display welding is not possible.
i
14 Messages
Code Error description Note Rectification
E00
no program Selected programme number does
not exist.
Select a different char-
acteristic line
Instead of material thickness „--- "
is displayed and by pressing the
torch key „E00" shows up. Welding
is not possible at activated charac-
teristic line and set welding step.
Select a different weld
-
ing step
E01
Excessive tempera
-
ture
The equipment has been over
-
heated
Allow the system to cool
down in standby, check
the ventilation system