LORCH M-Pro BasicPlus, Operation Manual

Page: 48 / 328

Start-up
- 48 -
10.13
‰
The characteristic selection knob 65 and
the corresponding table are in the wire
feed casing.
The table content may differ from
your welding machine. The char
-
acteristic lines are set individually
for each machine type.
Â
Select the required material-wire-gas
combination from the characteristic table.
Â
Read the corresponding characteristic
number off from the right hand column.
Â
Set the corresponding number from the
table using selection knob 65.
‰
Below the characteristic number 0 (man
-
ual mode)
–
is the material-wire-gas combination
nullified. Wire feed and welding volt
-
age can be set manually.
–
the welding step (Basic Plus) instead of
material thickness will be displayed.
–
the must-value for welding voltage
(Control Pro) instead of material thick
-
ness will be displayed.
If an unassigned number is set with
the characteristic selection knob
65, the 7-segment-display 47 will
display the error message „noP“.
i
i
13 .4 Characeristic connection
65
Abb. 19: Characteristic table and selection knob