SECTION 4. DISASSEMBLY AND SERVICE
- 39 -
c.RECOIL STARTER ASSEMBLY
The recoil starter can cause personal injury, Wear safety glasses. Do not let the recoil spring
snap
a) Hook the spring outer hook in the reel groove,
and install the reel on the starter case, so that
the spring inner hook is hooked to the starter
case tab by turning the reel counterclockwise.
b) Feed the end of the rope through the hole in
the starter reel, and tie the rope end. Wind the
rope onto the direction shown, and wedge the
rope end in the notch on the edge of the reel.
c) With a short length of the rope extending from
the starter reel notch, pull the end of the rope
out of the case, feed it through the starter grip,
and tie a knot in the end of the rope.
d) Install the friction plates, friction spring, ratchet
pin, guide plate, and reel cover. Tighten the
reel cover bolt.
e) Rotate the reel three full turns in the direction of
the arrow.
f) Check the operation of the ratchet by pulling
the starter rope out several times.
