SECTION 4. DISASSEMBLY AND SERVICE
- 30 -
b.STARTER MOTOR
REASSEMBLY:
Replace the center bracket
assembly if positive brush
replacement is required.
CENTER BRACKET
REASSEMBLY:
Make sure that there is no
obstruction in the magnets.
HOUSING
REASSEMBLY:
Align the holes in the holder with
the positive brush terminals and
install the negative brush and
5×14 mm screws.
BRUSH HOLDER
CENTER BRACKET
REASSEMBLY:
Hold the armature upright, place
an offset wrench over the pinion
stop collar, and drive the collar
down exposing the snap ring.
DISASSEMBLY:
Check for smooth movement by
rotating the pinion gear.
Check the gear teeth for wear or
damage; replace if necessary.
Also, check the flywheel ring gear
teeth if the pinion gear teeth are
damage.
REASSEMBLY:
Visually inspect the commutator surface for
dust, rust or other damage. If necessary,
wipe it with a clean lint-free cloth. If rusted or
damaged, dress with a fine emery cloth.
REASSEMBLY:
Push in the brushes so they do
not interfere with the commutator.
INSPECTION:
Check for cracks or damage.
REASSEMBLY:
Note the installation direction.
ARMATURE
BRUSH
INSULATOR
