FAQS
Logicube OmniClone® Xi User’s Manual
81
Q
: My cloning session always stops at a certain point with a “Drive not ready” error message.
Why?
A
: The Master drive may have too many bad sectors for the unit to skip over. In rare cases,
sectors can also be too damaged for the unit to skip over. Please refer to the Scan Target Mode
and Repair Target Mode information located in Section 5
: Omnidiagnostics™.
Note that if Verify is set to 1% or 100%, the bad sector(s) may be on the Target drive.
Q
: Why does the clo
ning session stop with an “Invalid MBR” error message?
A
: This error comes up when the partition table or boot sector contains corrupt data. Despite the
error, the Master drive may still boot in a PC.
