CLONING MODES AND SETTINGS
Logicube OmniClone® Xi User’s Manual
33
How to turn the feature on or off
Please refer to the section “
Dirty Bit for NTFS
CleverCopy
” in
Section 9
– Compact Flash (CF)
Card;
for the procedure to turn the Dirty Bit on or off
during cloning.
General Preferences
Introduction
Many of the settings that control overall functionality
of the OmniClone Xi are located in the General
Preferences screen. Tapping the General
Preferences icon located at the lower left-hand
corner of any other Settings screen can access this
menu. General Preferences includes such functions
as On Error, Set Option, Last Drive and other
functions to be added later.
On Error (Optional)
The On Error setting is a feature that is part of the
Omnidiagnostics option. It determines the behavior
of the unit in the case where bad spots are detected
on the Master drive. This setting has four options,
which include:
Skip
- This is the default setting. Skip will allow
the Logicube OmniClone Xi to continue by
stepping over the bad sector.
NOTE:
data in any skipped sectors will
NOT be copied to the Target drive.
Retry
- Retry option will instruct the Logicube
OmniClone Xi to make several attempts to read
data from the damaged area of the drive.
Recover
- Recover will attempt to recover as
many bytes of data as possible from each bad
sector that is encountered.
Abort
- This mode will cause the Logicube
OmniClone Xi to halt if an error such as a bad
drive sector is encountered.
NOTE:
The Omnidiagnostics™ option
must be installed before the On Error
settings can be accessed.
