LOFTNESS Battle Ax Light, Owner'S Manual And Parts Book

Page: 29 / 60

23 Battle Ax Light - Skid Loader OM
Tooth Sharpening (Cont’d)
NOTE: It is not necessary to match the factory angle
on the underside of the cutting edge when re-
sharpening. Sharpen each tooth at a slight angle
for each successive sharpening (represented by
the dashed lines shown in the illustration above).
When the cutting edge of the tooth is 1-1/8 in.
from the back side of the tooth, the tooth must
be replaced.
Storage
End of Season
• Clean entire Battle Ax Light thoroughly.
• Clean belt and sheaves, relax the belt tension. See
“Belt Adjustment” on page 21.
• Lubricate all parts of the machine. See “Lubrication”
on page 17.
• Make a list of all worn or damaged parts and replace
them.
• Paint all parts that are worn or rusted.
• Store Battle Ax Light in a clean, dry area.
• Secure hoses on machine to avoid damage.
• Review the Battle Ax Light operator’s manual.
Beginning of the Season
• Review the Battle Ax Light operator’s manual.
• Lubricate all parts of the machine. See “Lubrication”
on page 17.
• Tighten all bolts, nuts, and set screws. See “Torque
Specifications” on page 51.
• Adjust belt tension. See “Belt Adjustment” on page
21.
• Replace all damaged, worn or missing decals.
• Install the Battle Ax Light on an loader and test for
proper operation.
WARNING:
DO NOT allow ANY people or
animals within 300 feet of the work area
while operating this machine.
Maintenance