11
Battle Ax Light - Skid Loader OM
from the 25-7/8 in. pusher tube (6) attached to the left
side of the machine.
Remove the nut (7), lock washer (8), and bolt (9) securing
the pusher tube to the machine frame.
NOTE:
This 25-7/8 in. tube will be moved to the right
side of the frame in a later step.
Remove the 37-1/2 in. pusher tube (10) from the right
side of the machine by removing the upper nut (11), lock
washer (12), and bolt (13).
Remove lower nut (14), lock washer (15), and bolt (16).
NOTE:
This 37-1/2 in. tube will be moved to the left side
of the frame.
1
5
4
3
2
7 8
6
A
B
C
Align the top end hole of the 37-1/2 in. pusher tube (1)
into the desired position hole (A, B, or C) on the left side
pusher bar side plate. (Position A is shown in the image
above.)
Insert the bolt (2) from the outside and install the lock
washer (3) and nut (4) onto the bolt on the opposite side
of the pusher tube. Do not tighten at this time.
Align the bottom end hole of the pusher tube with the
hole (5) in the left side of the mulcher frame. Insert the
bolt (6) from the outside and install the lock washer (7)
and nut (8) onto the bolt on the opposite side of the
pusher tube. Do not tighten at this time.
(Procedure continued on following page.)
Set-up Instructions
Pusher Bar Assembly
The Battle Ax Light is shipped with the pusher bar in
an upright position. For shipping purposes, the left side
and right side pusher tubes are reversed and some
reconfiguring is required. Follow the procedure below to
get the mulcher into an operating position.
The pusher bar can be set into one of three different
operating positions as shown above. Determine which of
the three positions is desired before assembling.
2
6
1
10
5
4
3
13
12
11
16
15
14
9
8
7
NOTE:
Assembling the pusher bar requires two people
or the use of an approved lifting device (1) to
support the push bar as it is being adjusted.
Ensure pusher bar (2) is being safely supported.
Remove the upper nut (3), lock washer (4), and bolt (5)
Summary of Contents for Battle Ax Light
