Lofra MUSD48MMG700, Manual

Page: 36 / 56

36
Screw the leg up tight so the oven base is clamped between the
washer and the top of the leg. Once all four legs have been fitted
lift cooker onto the legs taking care to distribute the weight evenly
onto all four legs at the same time.
DO NOT tip the appliance onto its legs, always lift the appliance
onto its legs. (This will require two people).
For the installation, anchor the cooker by using the supplied kit referring to the relevant
drawing. We provides two brackets, which will serve to anchor the wall-terminal of the cooker.
We must fix the brackets to the wall, following the instructions of the drawings. We must then
slightly lift the cooker to let in the bracket on the crease of the wall-terminal or working top
cooker.
IMPORTANT: The cooker with and without backsplash must be raised slightly in order to
let the bracket on the edge of the hob.
WHEN ALL HOOKUPS ARE COMPLETE
Make sure all controls are left on the OFF position.
Make sure the flow of combustion and ventilation air to the range is unobstructed.
LEVEL THE RANGE
The floor where the range is to be installed must be level. Follow the instructions under
“Levelling the Range – Models Equipped with Levelling Legs”.
Slide the range into the cut-out opening.
MODELS EQUIPPED WITH LEVELING LEGS
Level the range and set cooktop height before installation in the cut-out opening.
1. Install an oven rack in the center of the oven.
2. Place a level on the rack. Take 2 readings with the level placed diagonally in one
direction and then the other. Level the range, if necessary, by adjusting the four leg
levellers with a wrench.