Loctite EQ RC24 RD, Operating Manual

Page: 50 / 60

OPERATING ELEMENTS
50
1. Enter the target quantity for the should amount , e.g. 1.00 ml or 1.00 g.
2. Enter the measured quantity for the actual quantity , e.g. 1.15 ml or 0.89 g. Use the
same unit for should amount and actual quantity.
3. Tap the Calculate button to calculate the correction factor.

The button will then change to OK:
Tap OK to confirm and apply the correction factor.
Numeric Keypad
Touching a button that requires an entry, opens the following numeric keypad:
Below the display Min and Max indicate the appropriate input limits. These depend on the
selected pump. If the entered value is outside the limits, it is invalid and will not be accepted.
Note
The correction factor 1.00 must always be set at the beginning of the calibration. To do
this, equal the should amount and actual value and have the correction factor calculated.