Dispensing
5
5.1.2.2
Cont
inuous Mode
This mode of operation is used for wettings of varying lengths or for the application of beads.
●
With the pressure regulator
8
set the dispensing
pressure to 0.50 bar (approx. 7 psi). An error
message „
Press. 0.83 NOK
“ with beeping is
possible. The value
0.83
[bar/psi] is only an
example for the indicated dispensing pressure
(see Chapter 7).
●
Press button
to store the dispensing
pressure setting as the comparison value for
automatic pressure monitoring.
The error message with beeping is eliminated.
●
Press button
. The lighting of the LED in
button
indicates continuous mode. The
indication of the dispensing time in the digital
display is set to 0.00 s and blinks.
●
Press the Footswitch
15
until the dispensed
quantity is roughly achieved.
When the dispensed quantity is achieved too slowly:
●
Increase the dispensing pressure and store. Check the dispensed quantity again.
Repeat this sequence until the desired dispensed quantity is roughly achieved.
☞
– Switching back to time controlled mode
without storage
of the dispensing time by renewed
pressing of button
. The LED in button
extinguishes. In the digital display, the dispensing time
previously stored for the time controlled mode reappears.
– Switching back to time controlled mode
with storage
of the dispensing time by pressing
button
. The LED in button
extinguishes. The indicated dispensing time is stored and the
display stops blinking.
If the desired dispensed quantity is not achieved:
●
With a larger (or smaller) dispensing needle, repeat the steps of Section 5.1.2.2.
CONT
CONT
CONT
CONT
CONT
R
CONT
bar
psi
97102
CONT
bar
psi
CONT
bar
psi
39
