Page 10
13. MANUAL DATA INPUT (MDI)
MDI - "GO TO" INSTRUCTIONS
1. Press the ESC key to reach primary screen
2. Press F3 - Execute
3. Press F2 - MDI
4. Press F1 - Go To
5. Press F1 - to set the X-axis coordinate, then press the ENTER key
6. Press F2 - to set the Y-axis coordinate, then press the ENTER key
7. Press F3 - to set the speed of the machine, then press the ENTER key
If necessary, press the DOWN ARROW once to VIEW BLK. Press F1 to review the coordinates
and speed.
8. Press the EOB/DRY RUN key on the controller and the machine will move to desired position
MDI - "RIP TO" INSTRUCTIONS
Move the machine to starting point of cut
1. Press the ESC key to reach primary screen
2. Press F3 - Execute
3. Press F2 - MDI
4. Press F2 - Rip To
5. Press F1 - to set the X-axis coordinate, then press the ENTER key
6. Press F2 - to set the Y-axis coordinate, then press the ENTER key
7. Press F3 - to set the speed of the machine, then press the ENTER key
If necessary, press the DOWN ARROW once to VIEW BLK. Press F1 to review the coordinates
and speed.
8. Press the EOB/DRY RUN key on the controller and the machine will cut a straight line from
resting position to the set coordinates
MDI - "RIP CUT" INSTRUCTIONS
Move the machine to starting point of cut
1. Press the ESC key to reach primary screen
2. Press F3 - Execute
3. Press F2 - MDI
4. Press F3 - Rip Cut
5. Press F1 - to set the speed of the machine, then press the ENTER key
6. When ready to cut, press F2 - Pierce On
7. When torch fires, press, and hold down, the jog key in the direction of the cut you want.
The jog keys are not pressure sensitive during Rip Cut. The torch will only move at the
designated speed.
H. WEISS MACHINERY & SUPPLY
H. WEISS MACHINERY & SUPPLY
PHONE: (718) 605-0395 - www.hweiss.com
