32
8, Programming
(Continued)
8-2, Replacing battery in remote and Wireless Wall Mounted
Remote(optional on some models)
CAUTION:
Incorrect battery replacement can be dangerous . Always replace
with the same battery type. Use longlife batteries.
Step1, Slacken screws on rear of remote control/wireless wall mounted remote and
remove cover.
Step2, Replace battery.
Step3, Check alignment of poles(+/-) place
Step4, Replace cover and tighten screws.
NOTE:
The wireless wall mounted remote is an optional on some models,
which is fitted inside the garage or room, so that the door can be opened
without the remote controls.
8-3, Programming Wireless Keypad (Optional on some models)
8-3-1, Instruction
This is a dual channel transmitters that are activated only after having entered a
Suitable combination.
The units are designed for installation in indoor or outdoor locations.
that ensures the utmost security because the transmitted code is changed at each
transmission session.
The estimated transmission range is 200 m in open space and 35 m indoors
The units are designed to ensure battery life equivalent to an estimated 2 years of
operation considering 10 transmissions/day
Audible signal
Status
1 Short beep
Keypad tone
1 Long beep
Auto power-off
3 Long beeps
Modification of combination confirmed
5 Short beeps
Error during combination input
10 rapid beeps
Battery low
8-3-2, Installation
Before physically installing the unit position it is good practice to perform a practical test to
assess their functionality and effective range.
Consider that range may be up to 25 or 30% less when battery power is low.
Apart from the distance from the receiver, the units should not be positioned in
the vicinity of or-worse still-in contact with metal structures, which could otherwise exert a
signal shielding effect. Thanks to the enclosure protection rating of IP 54, the digital
selectors can be installed outdoors if required.
