䚓
䚓
䚓
䚓
Assemble parts in reverse procedure of disassembly.
Wind and tighten jaw case head to the end and return
it to the position where convex and notch are aligned,
then set up Collar. At assembly, apply lubricant oil
JO-50
on
㻌
the
㻌
backside
㻌
of
㻌
jaw.
ᵐ
Cleaning the Spool section
Use stick such like plastic which does not
create damage and take
off the Spool from
Spool Cap A side.
If dust is accumulated at spool area, spool cannot move smoothly. Spool must be
cleaned when spool moves slowly or improperly.
Stop air supply.
Remove spool cap A and B with a spanner.
Spool
Cap A
Spool
Cap B
Spool
Plastic Stick
Be careful of
hole plugging
Clean up each part with a brush. In this case, make
sure that the small hole of the spool is not plugged.
Assemble parts in the reverse procedure of disassembly.
At assembly, apply lubricant oil on the O-ring of the spool.
䚷䚷䚷㻌㻌㻌
11
䠍
ᾅ
䠍
ᾀ
䠍
ᾁ
䠍
ᾂ
䠍
ᾃ
䠍
ᾄ
Align convex
and notch
Get down whirl-stop ring
Apply lubricant oil
ᒍᛖᾔ
ᾝ
ᾖ
ᾛᾘ
ᾢ
ᾗ
4'#55'/$.;
4'#55'/$.;
%.'#0+0)
&+5#55'/$.;
ḵ
ḵ
