Riveting for a long time generates chips and dust at several parts, which causes troubles.
The tool needs periodical cleaning and maintenance according to this manual.
Before cleaning and maintenance of each part, make sure that the power of air
compressor is turned off to stop air supply and eliminate the residual pressure.
Otherwise, you may be injured.
䞉
When assembling each part, apply lubricant agent such as grease at each sliding
area without fail. Otherwise, malfunction may occur.
䞉
All parts must be completely assembled and all fastening areas must be fastened.
ᾀ
If chips are clogged, jaw cannot work smoothly. Cleaning must be performed in every 3000 times
of crimping.
䞉
Jaw is a consumable supply. It must be replaced periodically. This tool uses high-endurance hard
tool material jaw (optional parts). When you order the part, order
“
hard tool material jaw, medium
”.
䞉
Do not loosen or remove an oil retaining screw. The oil retaining screw is used for air vent during
assembly.
䞉
Do not loosen or remove a jaw case or lock nut of jaw case. If it is loosened or removed, oil is
leaked from head area, which cause malfunction. Jaw case and lock nut of jaw case are mounted
at screw unit of oil piston so that they are not loosened. If they are accidentally loosened during
operation or during maintenance, ask repair.
Stop air supply.
Remove the frame head with auxiliary
spanner A.
Frame Head
Oil Retaining Screw
Pull Collar to the direction shown in the fi gure to
loosen jaw case head and remove it.
Whirl-stop Ring
Jaw Case Head
Remove jaw pusher spring, guide pipe,
jaw pusher, O-ring and jaw.
Clean up each part with a brush.
10
䠍
ᾄ
䠍
ᾃ
䠍
ᾂ
䠍
ᾁ
䠍
ᾀ
ᒍᛖᾔ
ᾝ
ᾖ
ᾛᾘ
ᾢ
ᾗ
⅐ ‿″※⁀⁆‷⁀″⁀‵‷
Cleaning the Frame head and Jaw case head section
ᵧᶋᶎᶍᶐᶒᵿᶌᶒ
&+5#55'/$.;
%.'#0+0)
➡
⚠
ᵵᵟᵰᵬᵧᵬᵥ
⚠
ᵡᵟᵳᵲᵧᵭᵬ
Jaw Case
Guide Pipe
Hand Grip
Jaw Pusher
Spring
Jaws
Jaw Case Head
Jaw Pusher
O-ring
P-10
