LNS Hydrobar Express 220, Troubleshooting And Spare Parts Manual

Page: 24 / 164

Chapter 1: Alarms
HYDROBAR EXPRESS 220
1-21
Servo Motor Positioning Error
SERVO MOTOR
POSITIONING
FOLLOWING ERROR!
DURNG SEQUENCE
NUMBER [@@]
POSSIBLE CAUSE:
MECHANICAL OBSTACLE
PREVENTS BAR STOCK
TO FEED OUT
Description:
The Servo Motor Following Error alarm occurs due to a mechanical obstacle preventing the bar stock from feeding out. The torque on
the servo motor will build up when the obstacle prohibits the stock from moving, once the torque reaches a certain limit the PLC
instructs the servo amplifier to quit pushing and this alarm message appears on the remote control station.
Solution:
Seq. # Solution
##
Alarm needs to be cleared. Press the STOP key on the remote control station to clear the message and reset the
alarm.
•
Check for any mechanical obstacles that the bar stock may be hitting. Remove obstacle if this is the case.
•
Check the bar stock diameter. Make sure that the actual diameter is the same as the value entered in for the
corresponding parameter in the
Part Setup
menu.
•
Check the alignment between the bar feeder and the lathe. The lathe or the bar feeder may have shifted over
a long period if either is not lagged to the floor securely.
If the problem persists please contact LNS America, Inc. for further information.