39
Blaze Air Outputs:
(See
Section 5.6: Menu: Setup Parameters
for setting up the polarity of the outputs and other
setup parameters)
Blaze Air Alarm (Normally Energized)
Signal from the Blaze Air that is ON when the Blaze Air is in Auto or Jog Mode and there are no
faults. If there is a fault, this signal will turn OFF until the fault is cleared and the Blaze Air is
reset.
Unload Complete
Signal from the Blaze Air that indicates the part has been loaded into the Lathe or unloaded from
the Lathe. This signal will stay on for 1 second.
Auto-Cycle
Signal from the Blaze Air that indicates that the Blaze Air is in Automatic Mode.
Ramp Full
Signal from the Blaze Air that indicates that the unload ramp is full. See
the Section 5.6: Menu:
Setup Parameters
/
P3: Ramp Full Setup
for a full description of the operation of this output.
Summary of Contents for Blaze Air
