Maschinenvertrieb
LIYU DMS GmbH
www.liyu-dms.com
68
Feeding
1. Make sure that the lifting rod is at the lowest point before feeding, if not, rotate the
button to the left and make the lifting rod descend to the lowest point.
2. There are two working modes for the developing machine, namely independent work
of developing machine and linkage work of developing machine and direct injection
machine. Hence there are two feeding methods for developing machine. Feeding
diagram is shown as follows.
Independent work:
before power-on, properly place the developing machine by
fixing four supporting feet at the bottom of the machine. Materials shall be placed
at the middle position between the two rubber rollers. Ensure the materials are tidy
and flat during feeding.
Linkage with developing machine:
properly place the developing machine before
power-on so that the central line of developing machine is aligned to that
of direct injection machine, two machines in relatively parallel with the spacing of
90CM. Please ensure the materials are tidy and flat during feeding.
