Maschinenvertrieb
LIYU DMS GmbH
www.liyu-dms.com
56
7. During the printing process, you can suspend the printing task by clicking pause button
and resume the printing task by clicking continue button. Or, you may cancel the
printing by clicking cancel button.
8. If printing task is conducted on heavy chemical fabrics, use M4x10 bolts (20 in total
as shown in the following circles) to install working table plate and two sets of working
table end plates (as needed for 3.2m) on the working table, as shown in the figure:
Refer to
LiyuPrint Operation Manual
for specific configuration and operation.
Sublimation paper printing test
Printing process:
1. Unlike polyster fabric printing, you will use M4x10 bolts (eight in total as shown in
the circles below) to install working table plate on the profile bedplate before
installing the media and install the media in the central position of the machine, as
shown in the figure:
2.
Open the lower right case and you will see fan inverter control panel with the
function of controlling fan on/off and its suction capacity. Start the fan and adjust
the wind force while printing sublimation paper media, as shown in the following
figure:
Working Table End Plate
Working Table Plate
Working Table End Plate
Working Table Plate
profile bedplate
