16
17
BOLTS (A)
SPRING WASHERS (B)
LEFT CONSOLE MAST
LEAD WIRE
CONSOLE CABLE
ARC WASHERS (C)
MAIN FRAME BRACKET
RIGHT CONSOLE MAST
LS
PRO
2 ASSEMBLY
STEP 1
A Open
HARDWARE FOR STEP 1
.
B Pull
LEAD WIRE
through
RIGHT CONSOLE MAST
.
After pulling the
LEAD WIRE
through the mast, the
top of the
CONSOLE CABLE
should be located at
the top of the mast. Detach and discard
LEAD WIRE
.
C Place
RIGHT CONSOLE MAST
over
MAIN FRAME
BRACKET
.
D Attach
CONSOLE MAST
to
MAIN FRAME
BRACKET
using 3
BOLTS (A)
, 3
SPRING
WASHERS (B
) and 3
ARC WASHERS (C)
.
E Repeat steps C–D on other side.
NOTE: Do not pinch console cable when placing
the mast onto the main frame bracket.
BOLT (A)
20 mm
Qty: 6
SPRING WASHER (B)
8.2 mm
Qty: 6
ARC WASHER (C)
8.4 mm
Qty: 6
HARDWARE FOR STEP 1
:
LS
PRO
2 ASSEMBLY
STEP 2
A
Open
HARDWARE FOR STEP 2
.
B
Feed
HANDLEBAR CABLE
through
CONSOLE MAST BRACKET
and out through
the top of
CONSOLE MAST
.
C
Slide
HANDLEBAR
onto
CONSOLE MAST
BRACKET
and attach using 3
BOLTS (A)
,
3
SPRING WASHERS (B)
and 3
FLAT
WASHERS (D)
.
D
Repeat on other side.
BOLT (A)
20 mm
Qty: 6
SPRING WASHER (B)
8.2 mm
Qty: 6
FLAT WASHER (D)
8.2 mm
Qty: 6
HARDWARE FOR STEP 2
:
BOLTS (A)
SPRING WASHERS (B)
HANDLEBAR CABLE
CONSOLE MAST
FLAT WASHERS (D)
HANDLEBARS
CONSOLE MAST BRACKET
NOTE: Be careful not to pinch any wires
while attaching the handlebars.
NOTE: Do not tighten bolts until step 3 is complete.
LS
PRO
2
LS
PRO
2
LSPRO1and2_OM_Rev1_9.indd 16-17
8/22/11 4:02 PM
