14
15
SCREWS (E)
MAIN FRAME BOOT
BOLTS (F)
END CAPS
LS
PRO
1 ASSEMBLY
STEP 4
A
Open
HARDWARE FOR STEP 4
.
B Attach
MAIN FRAME BOOTS
using 4
SCREWS (E)
.
C Attach
END CAPS
using 6
SCREWS (F)
.
SCREW (F)
15 mm
Qty: 6
SCREW (E)
20 mm
Qty: 4
HARDWARE FOR STEP 4
:
BOLTS (A)
SPRING WASHERS (B)
CONSOLE
CONSOLE MAST
ARC WASHERS (C)
CONSOLE &
HANDLEBAR
CABLES
LS
PRO
1 ASSEMBLY
STEP 3
A
Open
HARDWARE FOR STEP 3
.
B
Gently hold the
CONSOLE
above the
CONSOLE MASTS
.
C
Connect the
CONSOLE & HANDLEBAR
CABLES
, carefully tucking wires in masts to
avoid damage.
D
Attach each side of the
CONSOLE
using 3
BOLTS (A)
, 3
SPRING WASHERS (B)
and 3
ARC WASHERS (C)
.
E
Fold the deck into the upright position until
the foot latch engages. Rotate the
CONSOLE
MASTS
until the spacing between the
handlebars and the deck are the same. Tighten
BOLTS
from step 1 and then step 3.
BOLT (A)
20 mm
Qty: 6
SPRING WASHER (B)
8.2 mm
Qty: 6
ARC WASHER (C)
8.4 mm
Qty: 6
HARDWARE FOR STEP 3
:
YOU ARE FINISHED!
This treadmill has a pre-waxed belt and
should never be lubricated or waxed.
Lubricating or waxing the belt can cause
damage that is not covered by the
warranty.
IMPORTANT
LS
PRO
1
LS
PRO
1
LSPRO1and2_OM_Rev1_9.indd 14-15
8/22/11 4:02 PM
