22
5.3 Check sense of rotation of saw blade (see 3.5)
5.4 Cutting (see 3.7)
5.5 Cutting quality of the saw blade
Should the saw blade loose its cutting quality after a longer operation term, some cuts into lime clay
bricks or some similar material will „regrind“ the blade.
5.6 Change of cooling water
Strongly polluted water reduces the lifetime of pump and saw blade.
•
When used frequently, replace water daily and remove the sawing mud, too.
•
Clean the suction sieve of the pump each time when replacing the water.
5.7 Angle cuts
- Mount the angle stop (Pos. 18) in the table groove (Pos. 10)
- Turn the eccentric by the clamping lever (Pos. 17)
- Loose the eye bolt
- adjust desired angle
- Tighten eye bolt
- Place the brick at the angle stop
6.
Dismounting
•
Turn mains switch (Pos. 9) back.
•
Remove connection cable.
•
In danger of frost you should take the water pump out of the water and let the
water drain off.
ATTENTION! Pumps that are already frozen must be thawed out before starting them.
•
Transport (see 4.)
