Rev: 05.20.2022
Page 16
CCD-0001745
Fig. 21
C
B
A
Fig. 22
C
A
B
5.
Remove the screws (Fig. 21A) from the rear sensor (Fig. 21B) and mounting plate (Fig. 21C) and remove
the old sensor from the mounting plate.
6.
When installing a new rear sensor, dry-fit the mounting plate (Fig. 22A) and the new rear sensor
(Fig. 21B) to the cross-member (Fig. 21A).
Note:
The pre-drilled holes in the plate are for mounting the rear sensor to the plate.
7.
Mark on the plate where the rear sensor will set.
Note:
Space between the sensor and the crossmember must be left so the wire harness will not
be pinched.
