Rev: 05.20.2022
Page 11
CCD-0001745
Error Codes
LCD Message
What's Happening?
What Should Be Done?
Excess Angle
Controller not properly secured.
Check and secure controller placement.
Excessive angle reached during
auto operation.
Relocate the 5th Wheel.
Excessive Angle
Controller not properly secured.
Check and secure controller placement.
Excessive angle reached during
manual operation.
Relocate the 5th Wheel.
Feature Disabled
Front of 5th Wheel below level
when starting auto level process
(only when trying to initiate
Hitch Recognition).
Using manual mode on the touchpad, retract rear
jacks (which includes the middle, if equipped) and
set landing gear (front jacks) to hitch height.
Touchpad power not cycled
between consecutive
leveling operations.
Turn touchpad off and then back on to reset
the system.
Zero point not set.
Set zero point.
Low Voltage
Battery voltage dropped
below 10.8V DC.
Check wiring - repair or replace.
Test battery voltage under load - charge or replace.
Out Of Stroke
Jack has reached maximum stroke
length and is unable to lift.
Check disposition of jacks. Relocate the 5th Wheel.
Unexpected high amp current stall.
Check jacks in manual mode or perform manual
override procedure. Repair or replace as needed.
Check for bent or damaged jacks. Repair or replace
as needed.
External Sensor
Bad connection or wiring from the
controller to the rear sensor.
Repair or replace connection to rear remote sensor.
Jack Time Out
Time limit exceeded for the
requested auto operation.
Check disposition of jacks.
Auto Level Fail
Unable to auto level due to uneven
ground.
Check disposition of jacks. Relocate the 5th Wheel.
Unable to auto level due to zero
point being set incorrectly.
Reset zero point.
Comm Error
Communication between controller
and touchpad has been lost.
Check harness for proper connections or damage.
Replace if necessary.
Bad Calibration
Sensor calibration values are out
of range.
Replace controller.
Internal Sensor
Internal sensor problem.
Replace controller.
Function Aborted
The user pressed a button
on the touchpad during an
automatic operation.
Restart automatic operation and then refrain from
pressing any buttons on the touchpad.
Hall Effect Short
Short circuit detected in one of the
hall effect circuits.
Test for short and repair or replace.
Touchpad Error Codes
To clear an error code from the touchpad, repair or otherwise correct the issue, then press ENTER. If the error
is still present, the message will be displayed again.
