Lippert Components Levelegs, Installation Operation & Maintenance

Page: 5 / 22

- 5 -
Dip Switch Configuration
•
In order to accommodate as many units as possible, there
is a set of four small “dip switches” on the control board
that must be configured. Refer to the following table and
figure for the required configuration for your RV.
NOTE: If any of the blank configurations are used (noted by
“DEAD POSITION) in the table below), the Controller will not
work. In this case, the Control Pad Leveler position LEDs will
flash up and down.
Configurations Rear Levelers Rear Levelers Stroke Length Front Levelers Front Levelers Stroke Length
0000 7.5K 15" of travel 5K Direct Drive 24" of travel
0001 7.5K 13" of travel 5K Direct Drive 24" of travel
0010 DEAD POSITION
0011 DEAD POSITION
0100 DEAD POSITION
0101 DEAD POSITION
0110 DEAD POSITION
0111 DEAD POSITION
1000 DEAD POSITION
1001 DEAD POSITION
1010 DEAD POSITION
1011 DEAD POSITION
1100 DEAD POSITION
1101 DEAD POSITION
1110 DEAD POSITION
1111 DEAD POSITION
NOTE: These switches MUST be configured correctly. Incorrect configuration can result in
poor performance or damage to the system.