- 7 -
CONTROLLER WIRING
All information below pertains to the diagram on the page 10
NOTE: Atwood recommends using the Plug n’ Play harness kit
•
If modifications to the harnesses must be made, please mimic the Atwood harnesses, and
follow the guidelines provided by the manufacturer of the harness terminals. Be sure any wire
crimps are strong enough as defined by the manufacturer. Poor connections can hurt system
function. Refer to the wire harness index for the pin outs of each harness. Do not
make any wires longer than specified below.
•
For any extra wire after installing a harness, fold end to end (do not coil) and tie as
shown. (see right)
•
Atwood does not guarantee wiring functionality if wires are modified and/or new or
different harnesses are made.
NOTE:
For all wires, use strain relief clamps to reduce damage to the terminals.
Auto Position Control Pads
NOTE:
Mount the control pad in a clean, dry, and lockable compartment.
1. Provide a space with the dimensions shown in the figure to the right for the control pad at
desired location.
Note:
Reference control pad when making cutout;
there is tight clearance. Also to ensure the longevity
of the product, mount keypad away from potential
sources of moisture: windows, cup holders, etc.
2. Use the corner holes to fasten control pad to
mounting surface using appropriate hardware for
surface.
3. Connect control pad wire harness to control pad.
4. Route the control pad wire harness to controller
and connect the two.
5. Fasten a strain relief clamp (not included) within
12” of the control pad. This is to prevent the wire
harness connection from being damaged at the
Summary of Contents for Levelegs
Page 4: ... 4 ...
Page 10: ... 10 ...
