- 13 -
TO SET AUTO POSITION (DEFINE LEVEL)
NOTE:
This same process can be used to reprogram AUTO position.
Set Home Position as
described above before setting an AUTO position.
1.
Switch Activation Switch to ON
and Press the ON/OFF button to activate the system.
2. Simultaneous press EXT and ALL and FRONT buttons.
This will extend
the front landing gear to be in contact with the ground.
LEDs for front
levelers will be blinking green to indicate landing gear is down.
3. Manually set preferred hitch detachment position by pressing EXT and FRONT or
RET and FRONT as needed.
4. Detach trailer lights, harness and hitch using manufacturer’s suggested procedure. Move tow
vehicle to safe position clear of RV.
5. Simultaneous press EXT and ALL and REAR buttons.
This will extend
the rear levelers to be in contact with the ground.
LEDs for the rear
levelers will be blinking green to indicate the rear levelers are down.
NOTE:
Do not move around the inside of the RV while levelers are operating. This
could throw off the balance of the RV and affect the system’s ability to function
correctly.
6. Simultaneously press and hold EXT and one of the directional buttons to raise the desired side
of the RV: FRONT, REAR, DRIVER, PASS.
7. Repeat step 7 until the RV has reached the desired position.
8. If during this process any levelers are extended further than desired, any pair of levelers can
be retracted to compensate. To perform this procedure, simultaneously press and hold RET
and one of the directional buttons to lower the desired side of the RV: FRONT, REAR,
DRIVER, PASS
NOTE:
Levelers cannot be manually retracted past the point of initial ground contact.
9. Press the ON/OFF button to turn controls off.
10. Press EXT button 5 times.
11. Press RET button 5 times.
12. Unit will respond by blinking all LEDs slowly.
13. Press ALL button 3 times.
LEVELING MANUALLY
1. If the tow vehicle is attached perform steps 1 through 5 as
described above in “TO SET AUTO POSITION (DEFINE LEVEL)”. If all levelers are already in
contact with the ground move to step 2 below.
2. Simultaneously press and hold EXT and one of the directional buttons to raise the desired side
of the RV: FRONT, REAR, DRIVER, PASS.
3. Repeat step 2 until the RV has reached the desired position.
4. If during this process any levelers are extended further than desired, any pair of levelers can
be retracted to compensate. To perform this procedure, simultaneously press and hold RET
and one of the directional buttons to lower the desired side of the RV: FRONT, REAR,
DRIVER, PASS
NOTE:
Levelers cannot be manually retracted past the point of initial ground contact.
5.
Press the ON/OFF button to turn key pad off and switch the Activation Switch OFF.
Summary of Contents for Levelegs
Page 4: ... 4 ...
Page 10: ... 10 ...
