- 21 -
PANEL LIGHTS BLINK “ON” AND “OFF”
•
An Auto Position is not set
Set the Auto Position, referring to page 13.
FALSE RET (FULL RETRACTION) ERROR MODE
•
Every 50 cycles, the levelers will relearn where the fully retracted position is. If this is more than 4”
different than before, the following occurs:
1. Warning alarm will sound.
2. Power is removed from the control box disabling normal operations. (This is done to
encourage operator to do a visual inspection of levelers prior to further leveling operations.)
3. The red and green LEDs for the particular leveler will blink on and off to indicate the system is
in an error mode.
•
To proceed,
1. Press ON/OFF. This will shut the warning alarm off.
2. Visually inspect the leveler.
3. If it is required, activate levelers to correct problem. Simultaneously press the EXT or RET
button and the two directional buttons (e.g. DRIVE and FRONT) that make up the position of
leveler of the lit LEDs. In error mode, any leveler can be activated in this manner.
4. Hookup the RV to the tow vehicle as described on page 14 for the description that matches the
current system situation.
5. Complete an ALL RETRACT operation as described on page 12 and system is now out of
error mode and ready for normal operations. Make sure that all levelers are at least 2”
extended before retracting.
RET ALL DOES NOT FULLY RETRACT LEVELERS
•
If all leveler indicator lights are solid green, reprogramming the HOME position is necessary. To
do this:
1. Simultaneously press the EXT and ALL and FRONT buttons. The leveler indicator lights will
all blink green when this is finished.
2. Disconnect power or signal to one of the rear levelers.
3. Simultaneously press the EXT and ALL and REAR buttons. This will send the disconnected
leveler into error. The leveler indicator lights will blink green and red, and an alarm will go off.
4. Press ON/OFF to turn off the alarm and to turn on the keypad.
5. Reconnect the leveler to power/signal.
6. Hookup the RV to the tow vehicle as described on page 14.
7. Simultaneously press the RET and ALL and hold for 5 seconds. Leveler indicator lights will
blink red while moving. Wait until all leveler indicator lights are solid green. You may hear a
brief clutch from each leveler. The new HOME positions should now be programmed.
8. Visually confirm that the levelers have fully retracted.
•
If any leveler indicator lights are blinking green, this means there was an emergency stop during
the ALL RETRACT process. To proceed:
1. If a rear leveler light is blinking simultaneously press RET and ALL and REAR.
2. If a front leveler light is blinking hookup the RV to the tow vehicle as described on page 13.
3. Simultaneously press RET and ALL and FRONT. Leveler indicator lights will blink red while
moving. Wait until all leveler indicator lights are solid green.
4. Visually confirm that the levelers have fully retracted.
SYSTEM IS BEHAVING STRANGELY
•
If levelers commonly clutch in extend or do not extend as far as they should be able to, the Dip
Switches may have been configured incorrectly.
•
Refer to page 5 and compare the unit’s leveling system with the dip-switch configurations
.
Summary of Contents for Levelegs
Page 4: ... 4 ...
Page 10: ... 10 ...
