Wireless Remote Control (RC)
Wireless Remote Control settings
The wireless RC had two groups of buttons: group A and group B. This allows for two generators
being controlled at the same time by one remote.
Group A uses the top 4 buttons of the RC. Group B uses the bottom 4.
The four buttons have the same function as the four buttons on the left of the generator display.
Setting up the RC:
-
Open the menu and go to tab “RC” (1).
-
Set the cursor on “CONTROLLING” (3).
-
Press the “ENTER” button, the selected setting will start flashing.
-
Pr
ess the “UP” and “DOWN” button to switch between groups.
-
Press the “ENTER” button.
-
Press the “MENU” button to return to the main screen.
Setting up a Remote Control
Up to 40 RC’s can be memorized by the
generator. To memorize an RC:
-
Open the menu and go to tab
“RC”.
-
Place the
cursor (7)
on
memorize RC (4)
and keep the “ENTER” button depressed.
-
Press a button of the RC.
-
Release the “ENTER” button.
-
Press a button of the RC. The
receiving symbol (2)
will appear if the generator is receiving a
signal form an RC. In case the
symbol doesn’t appear repeat the procedure.
-
Press “MENU” to return to the main screen.
Erasing RC memory
To make sure an RC doesn’t work with a certain generator anymore, the whole RC memory must
be erased. Once the procedure complete, any RC that needs to be used with the generator in
question will have to be memorized again.
To erase the memory:
-
Open the menu and go to the “RC” tab.
-
Place the
cursor (7)
on
erase all (4)
and keep the “ENTER” button depressed for 12 seconds until
the display shows
“READY” (4).
-
Release the “ENTER” button.
-
Press the “MENU” button to return to the main screen.
