Linde 336 Series, Service Training, Page: 165 / 168

Service Training
Section 2.10
Page 1
2.10 SPECIALS
2.10.1 PIN CONNECTORS
2.10.1.1 AMP-SAAB PIN CONNECTORS
The majority of the pin connectors fitted on trucks of the type 336 will be of the type AMP SAAB in the future.
These pin connectors are watertight, each pin having it`s own seal with the connections locking together
mechanically.
The following description will help to explain how to crimp the pins.
- Push the single seal (2) into the correct position over the insulated wire (Ensure that the shrouded end (5)
is in the correct position on the insulated wire)
- With the aid of a pair wire strippers remove 5 mm the insulation, taking care not to demage the inner wire.
- The insulation of the wire must protude 1 mm from the seal (2).
- Place the wire (3) with the seal (2) into the connector pin (1) as illustrated below.
- With the crimping pliers WM 145 first crimp the connector pin onto the seal (2) in the area marked (4)
- Secondly the contactor pin should be crimped in the area marked (6)
- Press fully the contactor pin with attached wire into the plug housing.
NOTE: To remove the contactor pin there is a special extraction tool WM 143 available. For the smaller
contactor pins on the 42pin connector there is also a extraction tool WM 141available.
09/96