English
English
10
Oxo and Fast Mate Gun Adapter
Installation
Using the Oxo or FastMate gun adapters requires a
K3344-1 Standard #4 gun adapter to be installed in the
wire drive.
1. Turn power OFF at the welding power source.
2. Using a Phillips screw driver, loosen the screw
securing the gun adapter cover. Remove the gun
adapter cover.
A. Screw
B. Gun
Adapter
Cover
Figure #17
3. With a 3/4” wrench, remove the bolt holding the
electrode lead to the gun adapter.
A. Bolt
B. Electrode
Lead
Figure #18
4. Using pliers, remove the hose clamp and hose from
the gun adapter.
5. Bolt the electrode lead to the gun adapter, making
sure to route the lead straight down.
A. Bolt
B. Electrode
Lead
C. Keep Terminal and Lead Vertical
Figure #19
6. Assemble the gun adapter cover and secure with
the screw.
A. Screw
B. Gun Adapter Cover
Figure #20
7. Assemble the gas hose to the Oxo or FastMate gun
adapter.
8. Select the appropriate guide tube and secure with
the set screw.
A. Set
screw
B. Guide
tube
Figure #22
Wire size
Number of grooves in
guide tube
0.6 – 1.2mm
1
1.2 – 1.6 mm
2
1.6 – 2.0 mm
3
2.0 – 2.8 mm
4
9. Slide the Oxo or FastMate gun adapter into the wire
drive and secure with the thumb screw.
10. For FastMate gun adapters, connect the trigger
pigtail to the connector on the front of the feeder.
Rotating the Wire Drive
1. Turn power OFF at the welding power source.
2. Locate the socket head cap screw at the bottom of
the wire drive. Loosen, but do not remove the
screw.
A. Socket head cap screw
Figure #23
