FRONT WHEELS
In almost all configurations the front wheels must
remain parallel with the Cruiser base and rear wheels
(See Figure A.5). Improper adjustment of the front
wheels will cause inconsistent tracking of the joint,
accelerate wheel wear, poor operation on K396 track
and may lead to travel motor overload errors.
Only adjust the front wheels when welding a round
inside or outside seam 25 feet (7.6m) in diameter or
smaller (See Figure A.6). At all other times the front
wheels must be set to 90°.
See Figure A.7. To steer the front wheel to the left,
loosen bolt A and tighten bolt B to set the angle, then
snug bolt A.
To steer the front wheel to the right, loosen bolt B and
tighten bolt A to set the angle, then snug bolt B.
A-5
INSTALLATION
CRUISER
TM
FIGURE A.5 - FRONT WHEEL CONFIGURATION
FIGURE A.6 - ROUND 25 FOOT DIA. SEAM
FIGURE A.7 - SETTING THE ANGLE