GENERAL ASSEMBLY
Clamps
• Tighten clamp bolts to 25 ft-lbs (34 Nm).
• Use clamps with a key on horizontal tubes.
Collars
• Tighten collar screw to 42 in-lbs (0.3 Nm)
Lift Bail
• Tighten lift bail hardware to 24 in-lbs (0.17 Nm). Do
not overtighten or the mast may become distorted.
Chain and Mast Anchor
• The chain must be connected from the base to the
mast before lifting.
• Tighten all hardware as shown.
ELECTRIC SHOCK can kill.
• Improperly secured clamps
and collars may shift, causing
parts at electrode potential to
contact the tractor frame or
other components.
• Only
qualified
personnel
should install, use or service
this equipment.
------------------------------------------------------------------------
WARNING
FALLING EQUIPMENT can cause
injury.
• Lift only with equipment of
adequate capacity
• Be sure the machine is stable
when lifting.
• Do not lift the machine if the lift bail is damaged.
• Do not operate machine while suspended from
lift bail.
• Failure to properly secure the clamps, collars,
chains and lift bail may result in physical injury.
------------------------------------------------------------------------
WARNING
FIGURE A.1 - CLAMPS
FIGURE A.2 - COLLARS
FIGURE A.3 - LIFT BALE
FIGURE A.4 - CHAIN AND MAST ANCHOR
A-4
INSTALLATION
CRUISER
TM