11
Connect LED Pixels to Built-In RGB connectors
8 Built-in RGB connectors are located at the bottom of the front panel. Each built-
in LED connector supports a maximum of 75 LED pixels with Aurora Pro’s internal
power supply, for a total of 600 pixels across all 8 built-in RGB connectors.
Each built-in LED connector supports up to 500 LED pixels with additional Power
Top-Ups, for a total of 4000 LED pixels across all 8 built-in RGB connectors. Refer
to
Configure Aurora Pro
for details on how to set up Aurora Pro with additional
components, such as Power Top-Ups.
Required Components
• Aurora Pro
• Leader cables (optional)
4
• LED pixel strand(s)
Method
1. Power Aurora Pro OFF.
2. Unscrew the dust caps on each built-in LED connector.
3. If using leader cables, connect the male end of each LED pixel strand to the
female end of each leader cable. (Fig. 2)
Caution:
Do not connect LED pixels while Aurora Pro is connected to power.
Pro-Tip:
Any combination of built-in RGB connectors can be used, but patterns work
optimally when connected sequentially from 1→8.
4
Leader cables 15’ or greater require Power Top-Ups and Smart Extender/Receiver adapters. Refer to
the
Aurora Product Guide
for details on Power Top-Ups and Smart Extender/Receiver adapters.
Fig. 2: Male and female ends of RGB connectors
