10
7EN150104 Rev. 8
• 2020
www.hillrom.com
Assembly
4. Connect cables to the control box, see illustration.
Make sure plugs are fully seated.
1.
Lock both rear wheels. Remove the locking handles from
the base and place the lift mast in the foot of the base.
• Lift mast with lift arm, control box, motor for lift arm,
flexlink, locking handles and sling bar
• Base (including motor for width adjustment)
• Hand control with cable
Before assembly, make sure you have the following parts:
• Battery
• Bag containing Instruction for use, Quick Reference
Guide, charger cable and charger extension cable.
3. Secure the lift mast in the desired position with the
locking handles provided. After securing the mast
use "Pull-out-rotate" to set the locking handles in a
downwards position, see illustration.
2. The lifting height can be set to three different levels.
Select one of the three holes according to the illustration
above. The middle hole is recommended in most cases.
The lower hole of the lift mast is recommended for extra
high lifting height. The upper hole is recommended for
lower lifting heights. Please see the measurement table
in chapter "Dimensions".
6. Place the Quick Reference Guide in the holder o
n
the lift
mast.
XS
S
MS
M
L
XL
XXL
1
2
3
Pull-out-rotate
Motor for base
adjustment.
Lift motor
Handcontrol
5. Connect the battery and secure it to the control box
racket. A click sound can be heard when the battery is
installed correctly.
