LD25x
•
Once we have reached and saved the last interpolation points
P16_x/
y
,
the routine will restart with
P01_x
again. You are free to double-check
your settings once more or to make corrections.
•
To finish the Teach procedure, keep
ENTER
key down for about 2
seconds. In the display you will read
StOP
for a short time and then the
unit returns to the normal operation. At the same time all linearisation
points have been finally saved.
NOTE
•
The unit will examine the constraint valid for the x-values of
interpolation points. Every interpolation point must be higher than its
preceding point. If this constraint is breached, all 6 decimal points will
blink automatically as a warning. Pressing the
CMD
key will not store
the illegal value, but result in an error text
E.r.r.-.L.O.
.
•
To exit the teach mode again, you have the following two possibilities:
1. Press the
ENTER
key for 2 seconds. On the display you will read
StOP
for a short time and then the unit will switch back to the
normal mode.
2. Just do nothing. After 10 seconds the unit will switch back to the
normal mode automatically. In both cases the parameters of
linearisation
P01_x
to
P16_
Y
will not change.
MAN LD25x E 1.0.odt
Special functions
38 of 44
