A Lantronix Company
SCS1620 Product Manual
15.00.032 Rev. B
Page 85
The SCS1620 system must be shut down (using the "
poweroff
" command) and
disconnected from power before replacing the Flash. The cover must be
removed, so if it is installed it must be removed from service so that the case is
accessible.
Shut Down the SCS1620:
1. You must be logged in as 'sysadmin'.
2. Type 'poweroff' and press Enter. The system will gracefully shut down and
close all files; after about two minutes, the front panel display will state
"OK to power off".
3. Turn the power switch(es) on the back of the unit off (O).
Remove the Cover:
1. Remove seven screws on the top of the cover, plus two on each side (for
the rack mount rails).
2. Lift the cover straight up and set it aside.
