A Lantronix Company
SCS1620 Product Manual
15.00.032 Rev. B
Page 77
It is recommended that the user only change the escape sequence if it causes
problems with the hardware or software used. It is also recommended that the
user avoid combinations of the
<CTRL>
key and other keys, as these
combinations are usually reserved for sending and receiving special characters
through the terminal. When the user changes the escape sequence, a window
with the hexadecimal representation of the old escape sequence will appear.
Pressing
<ESC>
to exit from the edit prompt will not work; it will add additional
<ESC>
characters (hexadecimal value
1B
) to the direct mode escape sequence.
If the user wishes to keep the old sequence, they need only to press
<ENTER>
.
Otherwise, they should press backspace to delete the old characters, then enter
the new sequence and press
<ENTER>
. If for some reason the selection is
unacceptable, an error message will appear and the sequence will revert to the
old character values.
Appendix E lists the hexadecimal codes for the ASCII character set.
