![background image](http://html1.mh-extra.com/html/lightronics/show-pro-sm-280/show-pro-sm-280_owners-manual_1915010011.webp)
OWNERS MANUAL
Page
11
of
12
SM - 280 DMX LIGHTING CONTROLLER
Version
20080324
Lightronics
Inc.
509
Central
Drive
Virginia
Beach,
VA
23454
757
486
3588
MUSIC AUTO RUN SCENE BANKS OR CHASES
The SM-280 contains an internal microphone which
can be used to synchronize bank or chase Auto Run
with music playing near by.
1. Push Delete/Music.
2. Activate Auto Run for a bank or chase.
As an alternative you can start the bank or chase first
and them push Delete/Music to switch to music sync.
Pushing Delete/Music while music Auto Run is active
will stop Auto Run.
SPECIAL SCENES
The SM-280 has 14 additional scenes which can be
programmed and accessed using the SPL Scene button
You can program them like a scene in a bank. The
display prompts for the scene numbers when Spl
Scene is in use.
MIDI OPERATION
The MIDI Channel assignment for the SM-280 can be
assigned in the Setup mode.
1. Push Setup. The display will appear as below.
2. Use the Up and Down buttons to scroll through the
setup options until the display shows as follows:
3. Use the speed slider to select a MIDI channel.
4. Push Program/Record to save the new assignment.
The controller indicators will flash briefly.
5. Push Setup to exit from the setup mode.
EXTERNAL MEMORY CARD
The SM-280 is supplied with a 4 MB external
memory card which can be used to automatically
record scene and chase program data. When a card is
installed, the Memory Select button can switch the
controller between its internal memory or the external
card. Controller/Fixture initial setup data is always
from internal memory.
External memory card operation is active when the
RED indicator on the Memory Select button is ON.
The card is a special purpose device intended ONLY
for use with the SM-280 controller. It cannot be used
with other devices.
If you install and activate the card when programming
scenes and chases then that information will be saved
to the card. If the card is active when you operate the
unit then the scene and chase data will come from the
card instead of the internal memory.
FOG MACHINE CONTROL
The rear panel of the SM-280 has a IEC connector for
remote control of certain fog machines. It looks like
a computer power cable connector.
DO NOT PLUG THIS CONNECTOR INTO A POWER
SOCKET OR APPLY AC LINE POWER TO IT.
The controller will be damaged if this is done.
If properly connected to a compatible fog machine
then the indicator on the controller FOG MACHINE
button will light when the fog machine is ready to use.
The FOG MACHINE button can be used to activate
the machine.
Setup
Select: + / –
Setup: midi_ch
midi_ch **