Lighthouse SOLAIR 1100LD, Operating Manual

Page: 23 / 188

Unpack, Inspect and Install
248083395-1 Rev 9 3-3
Accessories
Several accessories may be ordered to tailor the instrument to specific
needs and should be readied for use at this point.
• Temp/RH Wand (optional) - plugs into the instrument’s rear panel.
The 4-20mA probe monitors temperature (0° to 150° F or -17.8° to
65.6° C) and relative humidity (0% to 100%). Results are
displayed, printed (if printer is available) and can be downloaded to
the LMS XChange software for backing up and historical data
review.
• Air Velocity Probe (optional) - plugs into the instrument’s rear
panel. The probe monitors air velocity up to 200 feet/minute (1.016
m/sec). Results are displayed, printed (if printer is available) and
can be downloaded to the LMS XChange software for backing up
and historical data review.
• Differential Pressure Sensor (optional) - plugs into the
instrument’s rear panel. Monitors range from 0 - 0.5" H
2
O (124.5
Pa). Results are displayed, printed (if printer is available) and can
be downloaded using the LMS XChange software for back ups and
historical data review.
• Isokinetic Sampling Probe (standard) - for use in unidirectional
air flow to maximize correlation between counts and actual
particle-size distribution. Can also be hand-held for particle
counting in specific locations.
• ScanAir Filter Scanner (optional) - for use in scanning HEPA /
ULPA filters and seals for leaks and efficiency. Designed to sample
any enabled channel size 0.5
—
m or smaller at a flow rate of 1.0
CFM (28.3 LPM), the scanner can be remotely operated and
programmed for five separate audible alarm threshold values.
• ScanAir Pro Filter Scanner (optional) - for use in scanning HEPA
/ ULPA filters and seals for leaks and efficiency (including PTFE
Filter Media). Designed to sample any enabled channel size 0.5
—
m
or smaller at a flow rate of 1.0 CFM (28.3 LPM), the ScanAir Pro
provides a programmable touchscreen interface with audible and
visual alarms.
• Particle Scanner Diluter (optional) - Used in conjunction with a
SOLAIR 1.0 CFM particle counter and the ScanAir/ScanAir Pro
filter scanners, the integrated intelligent NIST Traceable diluter can
be configured with a unit specific dilution ratio.
• Shipping Case with Wheels (optional)