Lighthouse SOLAIR 1100LD, Operating Manual

Page: 29 / 188

Unpack, Inspect and Install
248083395-1 Rev 9 3-9
Figure 3-9 Removing Battery (Dual-Battery Units)
WARNING:
Replace
the instrument battery
only with those supplied
by Lighthouse
Worldwide Solutions or
the product warranty and
CE certification will be
voided.
Replace Battery
To replace a failed battery, follow steps 1 and 2 under “Remove the
Batteries” on page 3-8 to remove it. For single-battery units, follow
steps 1 through 3 in “Install the Optional Batteries” on page 3-5 using
Figure 3-8 to remove the original battery and Figure 3-2 through Figure
3-4 to replace it. For dual-battery units, follow steps 4 through 6 in
"Install the Optional Batteries" on page 3-5 using Figure 3-9 to remove
the original batteries and Figures 3-5 and 3-6 to replace them. Use
caution to prevent puncturing the battery, which can cause a fire or
explosion. Contact Lighthouse Worldwide Solutions to get
replacement batteries, P/N:
403027596-1, 403028044-1, or
403028229-1, or the CE certification will be invalid. All batteries need
to be replaced at the same time to avoid imbalanced charging and
shortening of battery lifespans.
Do NOT attempt to remove a battery that is swollen or too hot to
handle. Contact Lighthouse Worldwide Solutions support for
assistance.
Connect the Isokinetic Probe
The SOLAIR comes with an isokinetic sample probe, tripod stand and
a length of sample tubing that is lined with an electrostatic reduction
material to eliminate particle adhesion. The probe with tubing connects
to the sample inlet.
Detach
Cables