![background image](http://html1.mh-extra.com/html/light-my-bricks/10270/10270_manual_1911512060.webp)
Turn the power ON to test the lamp and window lights are working OK.
Note: If you experience any issues with the lights not working and suspect an issue with a
component, please try a different port on the expansion board to verify where the fault lies
(with the light or expansion board). To correct any issues with expansion board ports, please
view the section addressing expansion board issues on our
online troubleshooting guide.
21.)
Disconnect the following tiles from the top of the left side of the building. Connect the tile
with studs to the new position toward the back as shown below.
Summary of Contents for 10270
